RayRoc
Member
I was able to use some information on this site, it has helped me out allot, I thought I would contribute. Here is a drawing of a crank that I did up, I only had a picture of the crank, and the measurements of the throw pin as found on this site. Thanks for the help. I hope that this will help others looking for the information, and of course as there are very knowledgeable people here, you can help me out by pointing out problems or inconsistencies.
Obviously there are details missing, I am still working on that. I do not yet know the width of the end mains, the diameter of the bored holes through the mains or crank pins, or the precise diameter of the main journals.
There for, these drawings of whatever I put on here should not be considered cannon to the design of the Merlin, but might be useful just the same.
Cheers!
Ray,
Obviously there are details missing, I am still working on that. I do not yet know the width of the end mains, the diameter of the bored holes through the mains or crank pins, or the precise diameter of the main journals.
There for, these drawings of whatever I put on here should not be considered cannon to the design of the Merlin, but might be useful just the same.
Cheers!
Ray,