jbiplane
Well-Known Member
Does anyone have an idea where to source good quality gears to use in light engenes reducers?
Yes it is possible to produce, but using of shelf components says of moto could cut the cost.
For this power range helical gears with module 1.5 1.75 2mm will work fine. Big gear can have 56...60 teeth
and small 17...20
Yes it is possible to produce, but using of shelf components says of moto could cut the cost.
For this power range helical gears with module 1.5 1.75 2mm will work fine. Big gear can have 56...60 teeth
and small 17...20