103
Well-Known Member
Some of you know I striped a plug or two because I clearly did not use Anti Seize.
In the process I also lost two long reach 14mm Autolite plugs for my Mag. These have stopped production and the Unimog drivers have scooped them all up. With a little help from my fiends I managed to convert to MSD low Noise and impedance wires paired to NGK 1111 plugs. The Straight boots are multi directional which came in handy in a tight space. Brian Ton at Tonsperformacne made a set of four 34" wires and shipped for $55 June 2020. Give him a call!
I have attached a few pictures I will install tomorrow after measuring the ohms I expect 140-160 ohms per wire.
Regards
Matt
In the process I also lost two long reach 14mm Autolite plugs for my Mag. These have stopped production and the Unimog drivers have scooped them all up. With a little help from my fiends I managed to convert to MSD low Noise and impedance wires paired to NGK 1111 plugs. The Straight boots are multi directional which came in handy in a tight space. Brian Ton at Tonsperformacne made a set of four 34" wires and shipped for $55 June 2020. Give him a call!
I have attached a few pictures I will install tomorrow after measuring the ohms I expect 140-160 ohms per wire.
Regards
Matt
Attachments
-
5_32nd rivet 0.25 reach chamfered by file.jpg83.3 KB · Views: 25
-
Busness end done.jpg65.5 KB · Views: 27
-
Clip ready.jpg67.3 KB · Views: 27
-
Easy Peasey.jpg70.8 KB · Views: 29
-
Jurry strut .jpg70.5 KB · Views: 30
-
Plan.jpg66.6 KB · Views: 30
-
Project layout.jpg41.1 KB · Views: 28
-
Rivet Ready.jpg58.2 KB · Views: 27
-
Squid.jpg52.8 KB · Views: 29
-
Tons.jpg75.8 KB · Views: 25