BillM
Well-Known Member
I just bought a VW prop hub from Great Plains and have a question-
The hub has a 1.25" hollow to fit on a .85" long crank end. This leaves a .4" gap in there- is that correct?
I tried to email Great Plains at both of their email addresses and they both came back as "undeliverable" so that doesn't help ([email protected] & [email protected])
Anyone have any answer if the .4" gap is OK?
Thanks
BillM
This is the "linear" hub, not the "tapered" one
The hub has a 1.25" hollow to fit on a .85" long crank end. This leaves a .4" gap in there- is that correct?
I tried to email Great Plains at both of their email addresses and they both came back as "undeliverable" so that doesn't help ([email protected] & [email protected])
Anyone have any answer if the .4" gap is OK?
Thanks
BillM
This is the "linear" hub, not the "tapered" one