dandoranch
Member
My Vector 610 has a "jack shaft" from the motor to the prop.
The hub that came with the Vector 610 is trash.
I had a hub machined to mount the prop directly to the 7/8 inch shaft.
While tuning the engine etc the bolt thru the hub/shaft sheared.
Too much inertia from thr prop for the 2 cycle engine.
Therefore I will have to install a clutch or slipper assy to tak the shock out of the system.
Does anyone have any leads or info on getting one???
Regards
Vern
The hub that came with the Vector 610 is trash.
I had a hub machined to mount the prop directly to the 7/8 inch shaft.
While tuning the engine etc the bolt thru the hub/shaft sheared.
Too much inertia from thr prop for the 2 cycle engine.
Therefore I will have to install a clutch or slipper assy to tak the shock out of the system.
Does anyone have any leads or info on getting one???
Regards
Vern
