Bille Floyd
Well-Known Member
- Joined
- Sep 26, 2019
- Messages
- 1,223
I need a 5" diameter piece of aluminum round stock ; to make an offset
for the starter gear on my Atos project, (so the starter clears the rear of the prop).
I only need 3 " length ; but 4 to 6" would give me enough to try again , when
the first attempt fails , ( I'm not the best machinist around, but I have a Great 36" lathe).
Thanks : Bille
for the starter gear on my Atos project, (so the starter clears the rear of the prop).
I only need 3 " length ; but 4 to 6" would give me enough to try again , when
the first attempt fails , ( I'm not the best machinist around, but I have a Great 36" lathe).
Thanks : Bille