Flyingboyke
Active Member
Hi fellow builders
I recovered a working bendix KX155 NAV/COM from a helicopter and I want to put it in my stampe to use on COM mode.
I wanted to bench test it but powering it doesn't even light the display. Does anyone know which pins have to be connected to even light the display? I attached a screenshot of the pins, note that the right plug is optional and not installed here.
I put +13.8V on 14+R and ground on 15+S. So what else?
Any help is appreciated.
Thanks
Simon
Full installation manual here: https://www.dropbox.com/s/htgu6tw5ddmq83q/KX155_IM.pdf?dl=0
I recovered a working bendix KX155 NAV/COM from a helicopter and I want to put it in my stampe to use on COM mode.
I wanted to bench test it but powering it doesn't even light the display. Does anyone know which pins have to be connected to even light the display? I attached a screenshot of the pins, note that the right plug is optional and not installed here.
I put +13.8V on 14+R and ground on 15+S. So what else?
Any help is appreciated.
Thanks
Simon
Full installation manual here: https://www.dropbox.com/s/htgu6tw5ddmq83q/KX155_IM.pdf?dl=0
Last edited:
