wanttobuild
Well-Known Member
How do you handle long dry strips of reinforcement? Uni is easy enough, but how about a long strip on the bias?
A clear piece of tape that can be marked on with a fine point sharpie? Blue painters tape? Let me know how to get a very accurate placement.
On the technical question, say you had a 4130 tube that that you want to make a little more resistant to buckling
I would like to add a wrap of carbon on the tube. Is the orientation on the bias acceptable? thank you in advance
A clear piece of tape that can be marked on with a fine point sharpie? Blue painters tape? Let me know how to get a very accurate placement.
On the technical question, say you had a 4130 tube that that you want to make a little more resistant to buckling
I would like to add a wrap of carbon on the tube. Is the orientation on the bias acceptable? thank you in advance
Last edited: