Zoomzoooie
Well-Known Member
I got a Smith AW1a handle, AW201, AW203, AW205 tips, HTP2 gauge set and the RA921 and the Kevlar hoses are ordered. After reading though the booklet, they show the AW200 tip for up to 1/32" and AW201 for 1/32"
I called my supplier about a AW200 tip and they got back to me after talking with Smith saying it is discontinued.
I have a couple of questions:
Is the AW201 tip ok for .028 wall?
If so whats your settings?
If not, what are you using?
Should I get arrestors and check valves to use with the AW1a?
I have seen some mention they are not needed or will not work correctly with the low pressures used.
Also the AW1a handle is smaller then I expected. I'm finding holding it awkward with the knobs up front.
How do you hold yours? Knobs up, down or to the side? If knobs up do you put your finger between the knobs?
ZZ
I called my supplier about a AW200 tip and they got back to me after talking with Smith saying it is discontinued.
I have a couple of questions:
Is the AW201 tip ok for .028 wall?
If so whats your settings?
If not, what are you using?
Should I get arrestors and check valves to use with the AW1a?
I have seen some mention they are not needed or will not work correctly with the low pressures used.
Also the AW1a handle is smaller then I expected. I'm finding holding it awkward with the knobs up front.
How do you hold yours? Knobs up, down or to the side? If knobs up do you put your finger between the knobs?
ZZ