topspeed100
Well-Known Member
I was trying to avoid work and realised that I had done this once already.
I figured I had really low fpea design in my drawer and also counted the frontal area for it and seem that the relation is around 1/20 fpea/frontal area...and flaps out and gear extented 1/30 ( if compared the to the best fpea ) !!!
That is why I had to scrap the project since I intented to use 22 hp engine..the drag increased by 50% as the take off/landing form was initiated.
This was very streamlined design.
http://3.bp.blogspot.com/_1i7bx5vtc...AAKg/4te8aFEwAVg/s1600/1_1_1_FRONTAL_lo_d.jpg
---------------
The FPEA is considered a constant here ( the lowest possible ).
I figured I had really low fpea design in my drawer and also counted the frontal area for it and seem that the relation is around 1/20 fpea/frontal area...and flaps out and gear extented 1/30 ( if compared the to the best fpea ) !!!
That is why I had to scrap the project since I intented to use 22 hp engine..the drag increased by 50% as the take off/landing form was initiated.
This was very streamlined design.
http://3.bp.blogspot.com/_1i7bx5vtc...AAKg/4te8aFEwAVg/s1600/1_1_1_FRONTAL_lo_d.jpg
---------------
The FPEA is considered a constant here ( the lowest possible ).