As per title.
Is current affordable 3d material strong enough to make an Eiffel club up to say 50 hp?
If so, someone could put together a program / spreadsheet, you enter hub type and appropriate power / rpm, and presto! it prints you out a set of test clubs.
If someone did calibration runs on the first set, you could possibly compensate for the surface roughness, so you could use them as-printed without finishing.
Is current affordable 3d material strong enough to make an Eiffel club up to say 50 hp?
If so, someone could put together a program / spreadsheet, you enter hub type and appropriate power / rpm, and presto! it prints you out a set of test clubs.
If someone did calibration runs on the first set, you could possibly compensate for the surface roughness, so you could use them as-printed without finishing.