Vision Microsystems tach reset

Discussion in 'Instruments / Avionics / Electrical System' started by SSinton, May 22, 2009.

Help Support HomeBuiltAirplanes Forum by donating:

  1. May 22, 2009 #1

    SSinton

    SSinton

    SSinton

    New Member

    Joined:
    May 22, 2009
    Messages:
    1
    Likes Received:
    0
    Location:
    Paso Robles, CA USA
    I recently changed the backup battery in my Vision Microsystems EPI 800 system in my Glasair III. This resets some of the stored settings as well as the ACTT on the tachometer. Does anyone know how to correct the tach time? The folks at JPI say that I have to send the system in but I think there is a way to do it in the field.
     

Share This Page

arrow_white