The new project aircraft VP 12. Ukraine

[Alex Aero UA]

Hand lamination top part wing skin aircraft VP12 of the carbon fiber-reinforced plastic .

 

[Alex Aero UA]

The second stage of hand lamination top part wing skin aircraft VP12 of the carbon fiber-reinforced plastic (on the left matrix). Preparation for the firsthand lamination step on the right wing matrix. Installation of a device for installing the VP12 internal elevator set in composite vertical tail plane .

 

[Tom Nalevanko]

Nice work! Thanks for sharing...

Best,

Tommy

 

[Alex Aero UA]

The second stage of hand lamination top part wing skin aircraft VP12 of the carbon fiber-reinforced plastic (on the right matrix). Marking matrix horizontal stabilizer VP12.

 

[Alex Aero UA]

We made a matrix for the cover of the pilot canopy. Glued in the inner rudder set. We continue to work on assembling the wing of the aircraft (Pre-closing) .... And from July 20 we are going on summer vacation!

 

[Alex Aero UA]

We returned from vacation and started work on our VP12 aircraft project. We continue to manufacture elements of horizontal tail. Marking out the flipper matrix.

 

[Alex Aero UA]

We carry out a mock assembly of the power plant of the VP12 aircraft. We glue the rudder.

 

[Alex Aero UA]

We mark the stabilizer. The rudder was removed from the matrices. After trimming, we tried it on the plane . It looks pretty.

 

[Alex Aero UA]

We carry out manual lamination of the skin of the aircraft stabilizer VP 12 of the carbon fiber-reinforced plastic

 

[Alex Aero UA]

We mark the airplane elevator matrix. Putting together a fixture for pasting the inner stabilizer kit. Welding "combat" engine mounting. We carry out manual lamination of the skin of the airplane elevator VP 12 of the carbon fiber-reinforced plastic.

 

[Alex Aero UA]

Form the matrix of the main wing spar of the VP12 aircraft. Pre-closure of the wing in conjunction with the master model of the rear spar.

 

[Alex Aero UA]

We assemble the internal set of the stabilizer (ribs and longeron) in the device. We glue the inner set (ribs and longeron) of the stabilizer.