John Newton
Well-Known Member
Hello all,
I have some Post Graduate students I am currently working with that are involved in a project involving the use of a GEM engine, I was wondering if any of you have any experience of these engines, they are struggling to get any information/data on them, the engine in question has been bench run successfully but is yet to be installed in the finished project, my apologies that I cannot divulge more information at this stage. One area that they are struggling with in particular is intake duct design as we do not know how critical this is.
Thanks,
John
I have some Post Graduate students I am currently working with that are involved in a project involving the use of a GEM engine, I was wondering if any of you have any experience of these engines, they are struggling to get any information/data on them, the engine in question has been bench run successfully but is yet to be installed in the finished project, my apologies that I cannot divulge more information at this stage. One area that they are struggling with in particular is intake duct design as we do not know how critical this is.
Thanks,
John