I'm getting to the point where I can start running the engine, however when I bought it there was no exhaust system. I've been looking over the available exhausts from Leading Edge Airfoils, and I can't figure out which one will fit properly.
The cowling has a hole cut in the bottom from the previous owner's 503, so I'd like to get the pipe that curves under the engine mount. I think the sidemount config from the link above is what I'm looking for, but I don't think the single 90 degree elbow will get it where I want.
Do any of you Ridge Runner/Sky Raider/503 builders know specifically which pieces I need? I'll get up to the workshop later today and post pictures of the engine mount if needed.
The cowling has a hole cut in the bottom from the previous owner's 503, so I'd like to get the pipe that curves under the engine mount. I think the sidemount config from the link above is what I'm looking for, but I don't think the single 90 degree elbow will get it where I want.
Do any of you Ridge Runner/Sky Raider/503 builders know specifically which pieces I need? I'll get up to the workshop later today and post pictures of the engine mount if needed.
