imamac96
Well-Known Member
Hi all,
Hope this is the right place to post this since I couldn't find a place for CAD questions.
There are many tutorials for OnShape's sheet metal tool, but I can't find one that deals with bending over a curved surface edge.
For example, I can bend the rear tab on this airfoil, but it will not allow me to create a flage for the upper and lower curves:
Does anyone (*cough* Topaz) know how to do this? It works just fine in SolidWorks, but I prefer to stay on Mac, and I like the version control built into OnShape.
I'd be super grateful if someone could help me get over this hump.
Thanks,
Connor
Hope this is the right place to post this since I couldn't find a place for CAD questions.
There are many tutorials for OnShape's sheet metal tool, but I can't find one that deals with bending over a curved surface edge.
For example, I can bend the rear tab on this airfoil, but it will not allow me to create a flage for the upper and lower curves:
Does anyone (*cough* Topaz) know how to do this? It works just fine in SolidWorks, but I prefer to stay on Mac, and I like the version control built into OnShape.
I'd be super grateful if someone could help me get over this hump.
Thanks,
Connor
