• Welcome aboard HomebuiltAirplanes.com, your destination for connecting with a thriving community of more than 10,000 active members, all passionate about home-built aviation. Dive into our comprehensive repository of knowledge, exchange technical insights, arrange get-togethers, and trade aircrafts/parts with like-minded enthusiasts. Unearth a wide-ranging collection of general and kit plane aviation subjects, enriched with engaging imagery, in-depth technical manuals, and rare archives.

    For a nominal fee of $99.99/year or $12.99/month, you can immerse yourself in this dynamic community and unparalleled treasure-trove of aviation knowledge.

    Embark on your journey now!

    Click Here to Become a Premium Member and Experience Homebuilt Airplanes to the Fullest!

Madza 13b setup with Tracy Crooks EC2 controller help

Advertise with us
Find deals on amazon
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

I need help on the shaft position angle vs the position sensor location for the EC2 controller

  • Rotor/ sensor allignment

    Votes: 0 0.0%

  • Rotor EC2 angle programming

    Votes: 0 0.0%
  • Total voters
    0
8davebarker

8davebarker

Well-Known Member
Supporting Member
Joined
Feb 1, 2013
Messages
80
Location
Santa Barbara,CA
I need some help regarding the sync of the Madza 13b vs the shaft angle position sensors. The documentation for the Tracy Crooks EC2 controller shows the sensor at a 4:30 position with the blank rotor tooth at TDC . The engine I purchased has two sensors. A backup sensor at 3:00 and a primary sensor at the 6:00 position. Question ? How is the EC2 programmed to account for the differing sensor positions?
Dave Barker
 
You must log in or register to reply here.

Latest posts

Back
Top