Genius_P_Bear
Active Member
HI.
I'm new here.
I'm baby pilot, genius, retired world class 3D software engineer. and Bear .
I have very elementary. question.
There is some AL 7075 or AL 7068 casting. there is many high pressure casting of AL 7075.
but in my case. I considered centrifugal cast in most case.
Here is dumb question. ( Actually below is not my worry. it's from other's but I must check it out. )
If I spin it fast, at inside heavy molecular move outer side?
for example copper getting out ?
If so everything is too complicated.
P_Bear
This is what I try to make via 3D printer and automation.
<br>
I'm new here.
I'm baby pilot, genius, retired world class 3D software engineer. and Bear .
I have very elementary. question.
There is some AL 7075 or AL 7068 casting. there is many high pressure casting of AL 7075.
but in my case. I considered centrifugal cast in most case.
Here is dumb question. ( Actually below is not my worry. it's from other's but I must check it out. )
If I spin it fast, at inside heavy molecular move outer side?
for example copper getting out ?
If so everything is too complicated.
P_Bear
This is what I try to make via 3D printer and automation.
<br>
Last edited by a moderator: