• Welcome aboard HomebuiltAirplanes.com, your destination for connecting with a thriving community of more than 10,000 active members, all passionate about home-built aviation. Dive into our comprehensive repository of knowledge, exchange technical insights, arrange get-togethers, and trade aircrafts/parts with like-minded enthusiasts. Unearth a wide-ranging collection of general and kit plane aviation subjects, enriched with engaging imagery, in-depth technical manuals, and rare archives.

    For a nominal fee of $99.99/year or $12.99/month, you can immerse yourself in this dynamic community and unparalleled treasure-trove of aviation knowledge.

    Embark on your journey now!

    Click Here to Become a Premium Member and Experience Homebuilt Airplanes to the Fullest!

Search results

Find deals on amazon
Find deals on ebay
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. bradyaero

    Looking for some feedback on my ultralight design

    Hi, I would like to know if you see any problems that I should correct before building one. I am a bit concerned about the square tube tail boom, but would the triangle support structure tied into the landing gear provide enough stiffness? Any feedback appreciated, Greg
  2. bradyaero

    Flitter

    So I got tired of staring at the two sides of the flitter, putting off building a four foot hotwire, so I got out my carving knife (Chainsaw) and went at it. It's nice to see both sides together, I still have to do some fitting but in general, they fit, and it was a nice christmas present to...
  3. bradyaero

    Problem with Plugs

    I have a question about my plugs, When they were cut, a layer of thin cloth was epoxied over the low density foam. As the epoxy cured, it created air pockets under the skin. Now I have to figure out if I should leave them there and build up over them or should I strip off the cloth and start...
  4. bradyaero

    BradyAero

    Let the chips fly! Finally my design gets physical :)
  5. bradyaero

    Landing Gear Help

    Hi, I've been designing a square tube ultralight and have been having a hard time figuring out how to create a light and cost effective main landing gear. I've settled on two ways that might work, the first is tubing with a central 'welded mount that the tubing fits in, with a cross wire for...
  6. bradyaero

    Bending Plywood for Leading Edge

    If use 3mm baltic birch for my leading edges will it bend properly with a hot water bath or do I need to go to 2mm 'KOSKIPLY' type plywood? Thanks for any suggestions!
Back
Top