SVSUSteve's Recent Activity

Help Support HomeBuiltAirplanes Forum by donating:

  1. SVSUSteve liked Victor Bravo's post in the thread Sealant between aluminum.

    Do good workmanship, deburr everything, spray a thick coat of Zinc Chromate or Zinc Phosphate spray on the parts, and put it together...

    Oct 14, 2019 at 7:38 PM
  2. SVSUSteve replied to the thread How to prevent low-wing fuel system to draw air?.

    Of course, you could avoid that issue by being on the ground with no less than an hour of fuel (or a quarter of a tank for lower...

    Oct 14, 2019 at 7:02 PM
  3. SVSUSteve liked Dan Thomas's post in the thread How to prevent low-wing fuel system to draw air?.

    I'd also be concerned with the length of tubing from the engine to the pump. Long tubing has drag that would seriously reduce the...

    Oct 14, 2019 at 5:23 PM
  4. SVSUSteve replied to the thread How to prevent low-wing fuel system to draw air?.

    Honestly, they are not that hard to scale down to size. I think that would be the simplest way to address the problem in terms of both...

    Oct 14, 2019 at 5:19 PM
  5. SVSUSteve liked Victor Bravo's post in the thread Wing/paint protection film???.

    What Marc Z is pointing out is that some of the canard airfoils have had serious issues because of just this issue you brought up. Much...

    Oct 14, 2019 at 5:13 PM
  6. SVSUSteve liked Marc Zeitlin's post in the thread Wing/paint protection film???.

    Yes. Your concern is warranted, and you should not use ANYTHING, including a paint stripe, that causes a chordwise discontinuity in the...

    Oct 14, 2019 at 5:13 PM
  7. SVSUSteve replied to the thread Not quite so structural foams?.

    I imagine someone else already pointed it out but one of the major things you have to be aware of is that polystyrene dissolves if you...

    Oct 14, 2019 at 5:11 PM
arrow_white