reo12's latest activity

Homebuilt Aircraft & Kit Plane Forum

Help Support Homebuilt Aircraft & Kit Plane Forum:

  • R
    reo12 replied to the thread premix oil.
    I had a Wizzard up until the shop burned. It was hanging on the wall since 1979. I think it was an 18" cut. One of oh so many oddities I...
  • R
    reo12 replied to the thread 50 HP engine recommendations.
    I'd like to be added to the list of folks interested in your Twinstar.
  • R
    reo12 replied to the thread premix oil.
    Actually - Rotella T 15w40 was a multi use oil. It was intended for mixed fleet use in gasoline and diesel engines. I seem to recall it...
  • R
    reo12 replied to the thread premix oil.
    Yes - I do remember mixing 30wt motor oil at 16:1 ratio with leaded gas back when for $0.65 you could buy 2 gallons of gas or a 12 ounce...
  • R
    reo12 replied to the thread Scattering Ashes?.
    I have seen this done using a 2 seat Quicksilver MXL. These are a pusher ul type plane. The passenger doing the release failed to ensure...
  • R
    reo12 replied to the thread Thread Drift.
    That Guppy flies decent with a 277. I've known of a few with a 277
  • R
    reo12 replied to the thread Trailer Design - Resources?.
    Having just transported 2 planes over 100 miles using a trailer - this is a nice string. I used a modified American Aircraft open...
    • 20210916_091857.jpg
  • R
    reo12 replied to the thread MOGAS/E85 etc.?.
    000000000
  • R
    If all the prior discussion didn't get one thinking that the world is full of opinions - here is discussion on an EAA forum. Note that...
  • R
    reo12 replied to the thread MOGAS/E85 etc.?.
    I hope you understood that the deposits I mentioned were the result of a bacterial infestation - usually the result of prolonged...
  • R
    reo12 replied to the thread MOGAS/E85 etc.?.
    My experience in auto use with carburetors using E85/E10 50/50 ratio was around 12 - 13% fuel economy loss. I have an ethanol plant near...
  • R
    reo12 replied to the thread New canard designs?.
    Depends on the design. The Pterodactyl UL canard is not considered a lifting component. However - the American Aircraft Falcon UL and XP...
  • R
    reo12 replied to the thread New canard designs?.
    I've owned canard type planes. Sweeping the wing expands the C/G range. A good example is the American Aircraft single seat Falcon UL...
  • R
    Locating holes relative to the crank centerline. Dimensionally drawing? Is it for manufacturing or is it for determining what dimensions...
Top