Help Support Homebuilt Aircraft & Kit Plane Forum:
oriol
- Messages
- 836
- Reaction score
- 174
Latest activity Postings Media About
-
-
Yes, but that's $1,050 for the printer and $200 for the extended bracket plus shipping plus the computer you'll use to run the software... -
oriol replied to the thread 3D printing wing ribs?.Thanks Matthew! The trick for printing beams is cool, I did not knew about it. I had a conversation yesterday with a very...
-
Realistically, this might work for a high-end kit manufacturer but is still out of reach for amateur builders. Yes, 3D printers are far...
-
oriol replied to the thread 3D printing wing ribs?.Hi! Composite 3d printing seem cool for molds, but I do not know if the material used by a metal printing machine, has the same...
-
I asked this question a few years ago. The answer was, not with current tech or anything on the immediate horizon. Carbon fiber gets the...
-
oriol reacted to WonderousMountain's post in the thread Airfoil selection for a flying plank, how to achieve statical equilibrium? with
Like.
Sadly no, the arguement I gave seems kinda lazy and there is not much for backup. Also, switching from symmetric doesn't make it any... -
oriol reacted to Norman's post in the thread Airfoil selection for a flying plank, how to achieve statical equilibrium? with Like.
That depends on what you mean by "best". A horizontal stabilizer gives you more pitch authority and much higher pitch damping than a...
-
-
Loading…
-
Loading…
-
Loading…