Help Support HomeBuiltAirplanes Forum by donating:

oneturboneeded
Last Activity:
Oct 17, 2019 at 6:03 PM
Joined:
Jul 21, 2010
Messages:
85
Likes Received:
2
Location:
san diego, CA

Share This Page

oneturboneeded

Well-Known Member, from san diego, CA

oneturboneeded was last seen:
Oct 17, 2019 at 6:03 PM
    1. oneturboneeded
      oneturboneeded
      Hi I'm Shawn. You wrote me in 2010 and I never responded. Your message to me was: Hi, I saw your post in the how old are you thread and then saw you were building a Cozy and a CNC machine. I have 3 tabs open right now to various Instructable articles on CNC building. I'm building a Velocity XL-RG with an LS1 engine on it. It's getting close to flying. Anyway, just wanted to get in touch with you and learn more about your plans for the CNC and Cozy. I'm finally wrapping up the Cnc build.I am trying to decide wether to build a stock cozy, build the cozy in molded fashion, or a glasair like 4 seater with a different airfoil and construction and double slotted fowler flaps.
      How is your velocity build going?
    2. erikfranks
      erikfranks
      Hi, I saw your post in the how old are you thread and then saw you were building a Cozy and a CNC machine. I have 3 tabs open right now to various Instructable articles on CNC building. I'm building a Velocity XL-RG with an LS1 engine on it. It's getting close to flying. Anyway, just wanted to get in touch with you and learn more about your plans for the CNC and Cozy.
  • Loading...
  • Loading...
  • About

    Location:
    san diego, CA
    Current / Future projects:
    im getting ready to build a cozy IV but with female molds instead of mold less, and vacuum infusion. i also have a push pull 6 place canard I am designing, a 3 surface 4 place single, and a 4 or 6 place 3 surface a lot like the p-180.
    Past Projects:
    I worked on a t-18 in high school.
    im in construction, im building a 5.5'x12'x3.5' cnc router.

    fast flight.
arrow_white