Quantcast

jbiplane's latest activity

HomeBuiltAirplanes.com

Help Support HomeBuiltAirplanes.com:

  • jbiplane
    jbiplane reacted to Vigilant1's post in the thread Forum made EFI? with Like Like.
    I look forward to hearing more. Since we don't need a TPS in airplane use, that might make it easier to put the control board somewhere...
  • jbiplane
    jbiplane reacted to rv7charlie's post in the thread Forum made EFI? with Like Like.
    Are you saying that the controller mounts *on* the throttle body? Most controller companies recommend putting the controller on the cold...
  • jbiplane
    jbiplane reacted to Vigilant1's post in the thread Forum made EFI? with Like Like.
    Thanks, great news. Looking forward to more information as you can provide it.
  • jbiplane
    jbiplane reacted to Pops's post in the thread Forum made EFI? with Like Like.
    Nice looking job on the PC board.
  • jbiplane
    jbiplane replied to the thread Forum made EFI?.
    Yes, It will completely inside of throttle body. Designed to work OK at -45..+85 C. At the moment it is intended for my company engines...
  • jbiplane
    jbiplane replied to the thread Forum made EFI?.
    Finally my company ECU = digital ignition + injection integrating to throttle body will look like on this picture. We will make it...
    • Плата в заслонку.jpg
  • jbiplane
    jbiplane replied to the thread Forum made EFI?.
    Speeduino news 2 injection+ 2ignition channels 47x25mm board A bit bigger board low-cost and mini-sized ECU for speeduino firmware (45...
  • jbiplane
    jbiplane reacted to Vigilant1's post in the thread Forum made EFI? with Like Like.
    Gerald, That link didn't work for me (it dead-ended at the "acversailles.free.fr" site without going to the underlying page/document)...
  • jbiplane
    jbiplane reacted to Geraldc's post in the thread Forum made EFI? with Like Like.
    Original post edited with correct link . It is a pdf so translation is not so easy.
  • jbiplane
    jbiplane reacted to pictsidhe's post in the thread Forum made EFI? with Like Like.
    If I was going for super simple. MAF sensor from a car, shrink the body to suit. Analog circuit with 2 pots to vary high and low...
  • jbiplane
    jbiplane reacted to rv7charlie's post in the thread Forum made EFI? with Like Like.
    Unfortunately, it's not that simple. I can fly my RV6 at low altitude (around 1500-2000 feet MSL) at ~125 kts, with fuel flow anywhere...
  • jbiplane
    jbiplane reacted to TFF's post in the thread Forum made EFI? with Like Like.
    OS model engines has used EFI. The new one is quite advanced. The old originals had sensors for head temp and RPM. These were glow...
  • jbiplane
    jbiplane reacted to Protech Racing's post in the thread Forum made EFI? with Like Like.
    I use and sell Microsquirt. When I did the first few installs Iused all of the sensors. For racing you dont need much at all...
  • jbiplane
    jbiplane replied to the thread Forum made EFI?.
    Yes, I experienced since 2016 with Speeduino, Megasquirt, RusEFI. finally made in house EFI... But after saw 2-stroke Stihl 550i...
    • Схема 2 датчика инж.jpg
  • jbiplane
    jbiplane replied to the thread Forum made EFI?.
    For simple predictable load like propeller not required. RPM would controlled by throttle, engine get as much fuel as required on...
Top