Bit of thread drift; does anyone have guidance regarding exhaust pipe clearance? I am build a 6 to 1 system for a Skybolt with bungee gear. I need some clearance to avoid heat damage of the bungee cords but I would obviously prefer not too much.
Selling an unused, pristine set of plans for the Culp Special plus a second set of shop plans. I purchased these plans directly from Steve Culp and have only taken them out of the mailing tube a couple of times. Will not separate. $250 plus shipping from Wichita, KS.
Anyone have a set of plans they will never use? I know I can buy them new but I thought I would check here first. I'll pay up to $200 plus shipping for plans in very good condition.
Perhaps I missed it in the thread, was there any discussion of moving closer to an "Owner Maintenance" category like Canada? Or, I had seen a proposal for a Type Certified Non-Commercial with maintenance requirements similar to the current Experimental Amateur-built.
Bearhawk Plans #799, Shop plans from the Bob, Bobwheel plans and full set of Beartracks newsletters (CD). Replacement value well over $400 new. Sell for $200 plus shipping from Wichita or Montreal. Price is firm.