• Welcome aboard HomebuiltAirplanes.com, your destination for connecting with a thriving community of more than 10,000 active members, all passionate about home-built aviation. Dive into our comprehensive repository of knowledge, exchange technical insights, arrange get-togethers, and trade aircrafts/parts with like-minded enthusiasts. Unearth a wide-ranging collection of general and kit plane aviation subjects, enriched with engaging imagery, in-depth technical manuals, and rare archives.

    For a nominal fee of $99.99/year or $12.99/month, you can immerse yourself in this dynamic community and unparalleled treasure-trove of aviation knowledge.

    Embark on your journey now!

    Click Here to Become a Premium Member and Experience Homebuilt Airplanes to the Fullest!

1/2 VW versus Briggs, Kohler, Generac V-Twins

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

nheistand

Member
Joined
Mar 4, 2011
Messages
23
Location
Vinton, Iowa / USA
I see that the Generac and other V-Twin industrial engines are starting to show up on ultralight aircraft and powered paragliders. The great thing about these engines is the low cost, newer technology, and easy service/repair. They come with alternator, starter, and electronic ignition built in.

On the other hand, the 1/2 VW can be built with a magneto so no battery or alternator is needed so the weight can be kept down to 85lbs or so. Also the 1/2VW should be built with high performance parts like Mahle pistons, Scat Crank and Rods, etc. Everything in life is a trade-off.:) The cost for these engines will be about the same until you start putting extras on the 1/2VW like starter, alternator, etc. These parts can be very pricey. A nice 37hp 1/2VW with a magneto is $3400 without extras at Hummel Engines. However, I will build and sell a 37hp 1/2 VW for $2900 including prophub, magneto, exhaust, intake, and carb ready to go.

A stock 32hp Generac V-Twin is about $1700 without prop hub (including alternator and starter!:gig:). Both the industrial V-Twins and the 1/2 VW are rated at 3600rpm. Since the industrial engine and the 1/2VW are so similar in performance, the direct drive prophub should work as well on the industrial engine as it does on the 1/2VW. Props will be limited to about 54in in both cases. It is relatively easy to design a belt reduction drive for the industrial engines so a longer prop can be used and more thrust will result.

Now if I just had a low-cost redrive for the 1/2VW. What do ultralight builders think of these engines?
 
Back
Top