planecrazzzy
Well-Known Member
- Joined
- Aug 16, 2003
- Messages
- 330
Hey Guys,
There's not a big demand for this.... But sometimes it's needed...
What got me thinking about it , was making my own Sewing needles for
Rib Stitching.... So I drilled a hole into a piece of 1/16th inch welding rod....
Yeah.... Try it....
.
.
OK... The Idea I came up with is this....
The "Bit" is too small for the chuck to grab it , right ?
I have a couple sets of torch tip cleaners... Not the file type...
the kind that has tiny drill bits in the screw off top....
So , I figured I'd just Chuck up the whole tool....
It holds the Bit... The drill holds "it"
I don't know what size I need later for stitching....
But I know it won't be smaller than 1/16"
You "could" cheat and give it a flat spot with a hammer...
Anywho , Here's some pictures...
.
Gotta Fly...
.
.
There's not a big demand for this.... But sometimes it's needed...
What got me thinking about it , was making my own Sewing needles for
Rib Stitching.... So I drilled a hole into a piece of 1/16th inch welding rod....
Yeah.... Try it....
.
.
OK... The Idea I came up with is this....
The "Bit" is too small for the chuck to grab it , right ?
I have a couple sets of torch tip cleaners... Not the file type...
the kind that has tiny drill bits in the screw off top....
So , I figured I'd just Chuck up the whole tool....
It holds the Bit... The drill holds "it"
I don't know what size I need later for stitching....
But I know it won't be smaller than 1/16"
You "could" cheat and give it a flat spot with a hammer...
Anywho , Here's some pictures...
.
Gotta Fly...
.
.