I haven't heard of it done this way...
But my " Cut out " for my Spinner/Prop Clearance
wasn't very good... I needed a better "Mock up"
So I covered my Spinner in plastic, and then
covered it in Paper Mache....
After , I coated it with Elmers Glue....
It is helping get a better idea about the cut outs needed for
the clearance needed...
Just thought I'd share some pictures
Mike & "Jaz" in MN
Buttercup - STOL - Aircraft
Buttercup-STOL : Buttercup STOL
Firestar I&II - STOL - Aircraft
Kolb_Firestar : Firestar
Sometimes you just have to take the leap and build your wings on the way down...